Nathan Myers

Nathan Myers

  • Commented on Clickbait spasm: 14 gizmos I used in 2015
    About new music: you could do far worse than to consult the last few days' scarygoround.com....
  • Commented on Clickbait spasm: 14 gizmos I used in 2015
    "Printrbot Simple" 3D printer. Get the one with the heated bed. Scrub the bed/film with a cellulose sponge and acetone before printing. Print with PLA filament at 205°C nozzle, 70°C bed, 45mm/s bottom layer. (Same on any similar gadget. I...
Subscribe to feed Recent Actions from Nathan Myers

Following

Not following anyone

Specials

Merchandise

About This Page

Find recent content on the main index or look in the archives to find all content.

Propaganda